Category Archives: Tech Tips

Headers – Tech Tip

Posted on December 31, 2011 by

When it comes to engine design and tuning, there is a lot more to it than just picking parts and tweaking carbs or fuel maps. Just about every gearhead, from the most experienced engine builder to the average weekend hobbyist … Continue reading →

Posted in Announcements, Tech Tips | Leave a comment

Dyno Tech Tip

Posted on February 18, 2011 by

Sorry for not getting a new Tech Tip out recently, but I have been a bit more consumed than usual with some project bikes in the shop. I just finished another blown Gen 1 Max engine build and we have … Continue reading →

Posted in Announcements, Tech Tips | 2 Comments

Horsepower Tech Tips

Posted on January 30, 2011 by

First off, I would like to ask that any of you reading these articles with an interest in learning more about a specific motorcycle performance or preparation, please leave me a message in the comment section. I can add your … Continue reading →

Posted in Tech Tips | Leave a comment

Carburetor Tech Tips

Posted on January 23, 2011 by

I will cover a few paragraphs of fuel flow metering first to give you all an idea of what an internal combustion engine would like to “see” in terms of the carburetor functions. On the dyno we adjust jetting or … Continue reading →

Posted in Tech Tips | 2 Comments

Vboost Tech Tip

Posted on January 14, 2011 by

When you first switch on your ignition you can hear the v-boost servo cycle through an open then closed procedure, checking it’s function through its full range. If you would like the v-boost to stay open all time you may … Continue reading →

Posted in Tech Tips | 1 Comment